Matrix T3X-02 - 9.11 SPEED SENSOR REPLACEMENT

32
1) Turn off power to the treadmill and disconnect the power cord.
2) Remove the front shroud as outlined in Section 9.1.
3) Unplug the speed sensor wire from the MCB (Figure A).
4) Remove the 2 screws holding the speed sensor to the motor (Figure B).
5) Remove the speed sensor (Figure C).
6) Reverse Steps 1-5 to install as new speed sensor.
7) Test the treadmill for function as outlined in Section 9.23.
FIGURE A
FIGURE B
FIGURE C
9.11 SPEED SENSOR REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE