15
7.1 USING SERVICE MODE
1) To enter Service Mode, press & hold the INCLINE DOWN and
SPEED DOWN keys at the same time for 3-5 seconds until Manager
Mode appears on the display.
2) Press the INCLINE or SPEED keys until Service Mode appears on
the display (Figure A) and press ENTER.
3) To scroll between settings in the Service Mode, press the INCLINE
or SPEED keys.
4) Press ENTER to modify the settings once displayed.
5) Press any INCLINE or SPEED key to change the value of the set-
ting.
6) Once the setting is correct, press ENTER to save.
7) Press the EMERGENCY STOP to exit Service Mode..
7.2 SERVICE MODE OVERVIEW
FIGURE A
CHAPTER 7: SERVICE MODE
CODE DEFAULT OPTIONS DESCRIPTION
Service 1 Display Test Press the ENTER key repeatedly
to check each set of LEDs on the
display sequentially.
Service 2 Keypad Test Press any key and the display
should show the corresponding
message.
Service 3 Distance / Time Distance:
Mile 0 - 99999
Kilometer 0 - 160898
Time:
0 - 999999
Manually sets the Accumulated
Distance and Time.
Service 4 CSafe / RF Test Press the ENTER key to test CSafe.
Press the ENTER key again to test
the RF module.
Service 5 Error Log Shows the last 10 errors. Press
and LEVEL UP and DOWN for 3
seconds to clear the errors.
Service 6 Set Date / Time Press the LEVEL keys to move
cursor, the number keys to set date
/ time, and the ENTER key to save.
To Next Page
Loading...
