35
9.2 REAR ROLLER REPLACEMENT
1) Remove one of the rear end caps using a Phillips screwdriver (Figure A).
2) Remove both rear roller adjustment screws using an 8 mm Allen wrench (Figure B).
3) Remove the rear roller from the running belt (Figures C & D).
4) Reverse Steps 1-3 to install a new roller. NOTE: Be sure to follow the instructions in Section 3.5 to re-tension the running belt.
5) Test the treadmill for function as outlined in Section 9.21.
FIGURE A FIGURE B
FIGURE C FIGURE D
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
