43
FIGURE E
FIGURE F FIGURE G
9.9 MOTOR REPLACEMENT - CONTINUED
7) Disconnect the motor ground wire from the motor and cut any tie straps holding the ground wire in place (Figure E).
8) Using an 8 mm Allen wrench, remove the four motor mounting screws (Figure F).
9) Lift the motor away from the treadmill (Figure G).
10) Reverse Steps 1-9 to install a new motor. NOTE: The speed sensor on the motor is not used on this model and should not be plugged into
the MCB.
11) Test the treadmill for function as outlined in Section 9.21.
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
