43
9.10 DRIVE BELT REPLACEMENT - CONTINUED
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE E FIGURE F
FIGURE G
7) Remove the two 8 mm screws from front roller (Figures E & F).
8) Lift the roller and remove the old drive belt (Figure G).
9) Reverse Steps 1-8 to install a new drive belt. NOTE: After installing a new belt, check it for correct alignment to the motor pulley before
setting the tensioner in place.
10) Test the treadmill for function as outlined in Section 9.21.
To Next Page
Loading...
Need help?
General
