55
9.19 HEART RATE GRIPS REPLACEMENT
1) Turn off power to the treadmill and remove the power cord.
2) Remove the 2 Phillips screws holding the 2 halves of the HR grip together (Figure A).
3) Disconnect the white wire from the bottom HR terminal and remove it (Figure B).
4) Disconnect the red wire from the top HR terminal and remove it (Figure C).
5) Reverse Steps 1-4 to install new HR grips.
6) Test the treadmill for function as outlined in Section 9.21.
FIGURE A
FIGURE B
FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
