36
9.5 CONSOLE KEYPAD / OVERLAY REPLACEMENT - CONTINUED
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE F
7) Peel the backing off of the new keypad and slide the ribbon cables through the slots in the console faceplate (Figures F & G).
8) Plug the ribbon cables into the UCB (Figure H).
9) Carefully line up the new keypad to the outline in the console faceplate. Once it is in place, press down on the keypad so that the adhesive
on the keypad bonds to the console (Figure I).
10) Peel the backing off of the new overlay (Figure J).
11) Carefully line up the new overlay to the outline in the console faceplate. Once it is in place, press down on the overlay so that the adhesive
on the overlay bonds to the keypad (Figure K).
12) Reverse Steps 1-3 to re-assemble the console.
13) Test the bike for function as outlined in Section 9.20.
FIGURE KFIGURE J
FIGURE IFIGURE H
FIGURE G
To Next Page
Loading...
