Matrix W1X ROWER

16
CHAPTER 6: PART REPLACEMENT GUIDE
6.6 PLASTIC CENTER COVER REPLACEMENT
1) Remove the console as outlined in Section 6.3.
2) Remove the handlebar from the rope as outlined in Section 6.4.
3) Remove the rubber center cover as outlined in Section 6.5.
4) Remove the 4 screws holding the plastic center cover to the frame (Figure A).
5) Lift up on the plastic center cover and at the same time pull the rope through the hole in the cover (Figure B).
6) Remove the plastic center cover (Figure C).
7) Reverse Steps 1-6 to install a new plastic center cover.
FIGURE A
FIGURE B
FIGURE C