Matrix W1X ROWER

30
1) Remove the middle shrouds as outlined in Section 6.2.
2) Remove the console as outlined in Section 6.3.
3) Remove the handlebar from the rope as outlined in Section 6.4.
4) Remove the rubber center cover as outlined in Section 6.5.
5) Remove the plastic center cover as outlined in Section 6.6.
6) Remove the handlebar bracket as outlined in Section 6.15.
7) Remove the 2 long screws / nuts holding the seat rail to the frame (Figures A & B).
8) Disconnect the console cable from the stroke sensor wire (Figure C) and pull the console cable off the unit.
9) Reverse Steps 1-8 to install a new console cable.
10) Test the rower for function as outlined in Section 6.19.
6.16 CONSOLE CABLE REPLACEMENT
CHAPTER 6: PART REPLACEMENT GUIDE
FIGURE A
FIGURE B
FIGURE C