CHAPTER 6: PART REPLACEMENT GUIDE
6.19 TESTING THE ROWER
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND PROPERLY
PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST THE MACHINE:
1) Without hitting start or entering any program modes, sit on the machine and hold the handlebar while initiating movement to simulate exercising.
While moving, listen for any odd noises or squeaks.
2) After stopping movement, press the ON/OFF button and begin using the machine.
3) Grasp the handlebar and move the seat to make sure that strokes are accumulating.
4) Check the console to make sure that distance is accumulating once strokes are registered.
5) Adjust the tension knob to make sure that tension changes are registering.
33
To Next Page
Loading...
Need help?
General
