Setup
Maverick MK2 Spot User Manual Rev. 4 -5-
3. SETUP
Each Maverick MK2 Spot has an auto-ranging power supply that works with an input voltage
range of 100 to 240 VAC, 50/60 Hz. To determine the power requirements for each
MK2 Spot, refer to the label affixed to the product. You can also refer to the
Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For mor
information, you may download Sizing Circuit Breakers from the Chauvet website
:
www.chauvetprofessional.com.
• Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
• Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
The Maverick MK2 Spot comes with a power input cord terminated with a True 1 compatible
connector on one end and an Edison plug on the other
end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Replacement
Disconnect this product from the power outlet.
1.
Using a flat-head screwdriver, unscrew the fuse holder cap from the housing. 2.
Remove the blown fuse and replace with another fuse of the same type and rating 3.
(F 10 A, 250 V).
Screw the fuse holder cap back in place and reconnect power.
4.
Make sure to disconnect the product’s power cord before replacing a blown fuse. Always
replace the blown fuse with another of the same type and rating.
To Next Page
Loading...