Maverick MK2 Spot - Fan, Dimmer, and Reset Settings; Resetting Specific Functions; Factory Default Reset

Operation
-14- Maverick MK2 Spot User Manual Rev. 4
Personality
To set which DMX personality to use, do the following:
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>. 1.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Personality, or touch the display where it 2.
says Personality.
If using the buttons instead of the touchscreen, press <ENTER>. 3.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select DMX 24CH or DMX 32CH, or touch the 4.
display where it says the desired option.
If using the buttons instead of the touchscreen, press <ENTER>. 5.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (cancel) or YES
(confirm) or touch the
6.
display where it says the desired option.
Press <ENTER>.
7.
Settings
To reach the Settings menu, follow the instructions below:
Press <MENU> repeatedly until the Home Screen shows on the display. Press <ENTER>. 1.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Settings, or touch the display where it 2.
says Settings.
If using the buttons instead of the touchscreen, press <ENTER>.
3.
Control Mode
The Maverick MK2 Spot can be set to respond to DMX, WDMX, Art-Net™ or sACN. The protocol
configuration must be set for the product to respond correctly to the controller(s). See the Menu
Map for more information.
To configure the protocol for the Maverick MK2 Spot, follow the instructions below:
Navigate to the Settings menu.
1.
Use <UP> or <DOWN> to select Control Mode, or touch the display where it says Control 2.
Mode.
If using the buttons instead of the touchscreen, press <ENTER>. 3.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select DMX, WDMX, sACN, ArtNet., or touch 4.
the display where it says the desired option.
Press <ENTER>.
5.
For WDMX control, ensure the antenna is raised and there are no obstructions between the
controller and the product. See WDMX Reset for troubleshooting information.
Pan/Tilt
Orientation
To set whether the pan or tilt orientation is normal or inverted:”
Navigate to the Settings menu. 1.
Use <UP> or <DOWN> to select Pan Reverse or Tilt Reverse, or touch the display where it 2.
says the desired setting.
If using the buttons instead of the touchscreen, press <ENTER>. 3.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (normal orientation) or YES (inverted 4.
orientation), or touch the display where it says the desired option.
Press <ENTER>.
5.
Display
Orientation
To set which way the display faces, do the following:
Navigate to the Settings menu. 1.
Use <UP> or <DOWN> to select Screen Reverse, or touch the display where it says Screen 2.
Reverse.
If using the buttons instead of the touchscreen, press <ENTER>. 3.
Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (display is normal), YES (display is 4.
inverted), or AUTO (the display automatically detects which way the product is facing and
orients itself accordingly), or touch the display where it says the desired option.
Press <ENTER>.
5.