Firmware Update
Maverick MK2 Spot User Manual Rev. 4 -31-
6. TECHNICAL INFORMATION
Maintenance
To maintain optimum performance and minimize wear, clean this product frequently. Usage and
environment are contributing factors in determining the cleaning frequency.
As a rule, clean this product at least twice a month. Dust build-
up reduces light output
performance and can cause overheating. This can lead to reduced light source life and
increased mechanical wear.
To clean your product:
Unplug the product from power. 1.
Wait until the product is at room temperature. 2.
Use a vacuum (or dry compressed air) and a soft brush to remove dust collected on the 3.
external vents.
Clean all external surfaces with a mild solution of non-ammonia glass cleaner or isopropyl 4.
alcohol.
Apply the solution directly to a soft, lint-free cotton cloth or a lens cleaning tissue. 5.
Wipe any dirt or grime to the outside edges of the lens surface. 6.
Gently polish the lens surfaces until they are free of haze and lint.
7.
Always dry the external surfaces thoroughly and carefully after cleaning them.
Do not spin the cooling fans by blowing compressed air into them.
Error Indication
Tilt magnetic sensor error
Rotating prism error detected
Gobo wheel 1 error detected
Rotating gobo wheel 1 error detected
Gobo wheel 2 error detected
Rotating Gobo wheel 2 error detected
Head fan 2 error detected
Head fan 2 error detected
Base fan 1 error detected
Base fan 2 error detected
Pan magnetic sensor 1 error detected
Pan magnetic sensor 2 error detected
To Next Page
Loading...