INTRODUCTION 1 - 1
SE-44R / SE-44
Ultrasonic Sensor
www.maxcess.eu MI 1026 1 A
Einführung.fm
1 INTRODUCTION
About these operating
instructions These Operating Instructions describe the installation, operation
and maintenance of the SE-44 sensor and provide important
instructions for proper use.
These Operating Instructions are directed to both the system
construction master as well as the operator who uses the SE-44
sensor in production. The Operating Instructions must be read
and used by all persons who have the responsibility of installing,
operating and maintaining the SE-44 sensor.
The Operating Instructions must be carefully kept and must
always be available throughout the service life of the SE-44
sensor.
Note:
This operating manual also applies to sensor SE-44R.
Translation of the original Operating Instructions:
These Operating Instructions are a translation. The original
Operating Instructions were composed in German.
Proper usage The SE-44 sensor is used for no-contact measurements of the
lateral offset of the material web that is being controlled.
The SE-44 is suitable for:
– Web edge guiding and
– Web center guiding for dual application.
The SE-44
sensor can be used to control both opaque and
transparent materials
. A web guide controller must be used with
acoustically transparent materials to calibrate the sensor to the
material. For more information, see the web guide controller
operating instructions.
The
SE-44
sensor must only be used in accordance with its
intended purpose and in a technically flawless conditions.
The SE-44
sensor
must not be changed or opened
To Next Page
Loading...
