SAFETY INSTRUCTIONS 2 - 3
SE-44R / SE-44
Ultrasonic Sensor
www.maxcess.eu MI 1026 1 A
Sicherheit.fm
∙ The parameters specified in Section
Technical data
must be
observed.
∙ Only accessory and replacement parts that have been
approved by Fife-Tidland GmbH may be used.
∙ No changes must be made to the sensor.
∙ Electrical lines must not be subjected to any mechanical
loads.
Operation
∙ Danger of injury by crushing
Ö Do not place your hands on or near moving parts (rollers,
material web, etc.) during operation.
∙ Danger of injury due to cutting on the edge of the material
web
Ö Do not place your hands on the edge of the (moving)
material web during operation.
Maintenance
∙ Danger of injury by crushing
Ö Maintenance work must only be performed on the sensor
when the power is turned off and the machine is stopped and
protected against being turned on again.
To Next Page
Loading...
