Maxcom MM320 User Manual

12
 After the battery is installed, place back the
back cover and slide it down into position.
Charging the Battery 2.2
Note: Only use the battery included in the set. Using
other batteries might damage the phone and void your
warranty.
Never plug in the charger if the back cover is removed.
To charge the phone:
1. Plug the charger into an electric socket. Plug the
other end of the charger into the jack located at the
top of the phone. A battery icon will start blinking as
soon as the charger is properly connected, and it
will keep blinking while the battery is charging.
2. As soon as the battery is fully charged, unplug
the charger from the electric socket, and then
from the phone.
As soon as charging is complete, there will be a
message on the display: “Charging Complete”, and the
icon will stop blinking.
Note:
o Before you start charging the battery, make
sure the battery is properly installed.
o Never remove the battery while charging –
doing so might damage the phone.

Maxcom MM320 Specifications

General

Display diagonal	3.2 \
Display resolution	240 x 320 pixels
Data network	GSM
SIM card capability	Single SIM
2G bands (primary SIM)	900, 1800 MHz
Mobile network generation	2G
Flash card support	Yes
Compatible memory cards	-
Maximum memory card size	32 GB
Talk time (2G)	5 h
Battery capacity	1000 mAh
Standby time (2G)	300 h
Form factor	Bar
Personal info management (PIM)	Alarm clock, Calculator, Calendar
Rear camera resolution (numeric)	2 MP
Cables included	USB
Multimedia Messaging Service (MMS)	Multimedia Messaging Service (MMS) is a standard way to send messages that include multimedia content to and from a mobile phone over a cellular network
Type	Feature phone
Product color	White

Weight and Dimensions

Depth	11 mm
Width	58 mm
Height	129 mm
Weight	110 g