PH50B
800-621-2789 PH50B Rev A.4 Page 13
BURNS AND FIRES
The muffler, muffler guard and other parts of the engine become extremely hot during the
operation of the engine. These parts remain extremely hot after the engine has stopped.
• Never remove the muffler guard from the engine.
• Never touch the muffler guard because it is extremely hot and will cause severe burns.
• Never touch parts of the engine that become hot after operation.
• Always keep materials and debris away from the muffler guard and other hot parts of the
engine to avoid fires.
CHILDREN AND BYSTANDERS
Tragic accidents can occur if the operator is not alert to the presence of children and/or
bystanders. Never assume that others will remain where you last saw them.
• Keep the area of operation clear of all persons, especially small children and pets. Keep
children under the watchful care of a responsible adult.
• Be alert and turn machine off if children enter the area.
• Before and while moving backwards, look behind and down for small children.
• Never allow children to operate the machine.
• Use extra care when approaching blind corners, shrubs, trees, or other objects that may
obscure vision.
SERVICE
• Always stop the engine whenever you leave the equipment, before cleaning, repairing or
inspecting the unit. Engine should be turned off and cool. Never make adjustments or
repairs with the engine (motor) running. Move the fuel and ignition lever to the off or
stop position.
• Always wear eye protection when you make adjustments or repairs.
• Keep all nuts and bolts tight and keep equipment in good condition.
• Never tamper with safety devices. Check their proper operation regularly.
• When servicing or repairing the machine, do not tip the machine over or up unless
specifically instructed to do so in this manual. Service and repair procedures can be done
with the machine in an upright position. Some procedures will be easier if the machine is
lifted on a raised platform or working surface.
• To reduce fire hazard, keep machine free of grass, leaves or other debris build-up. Clean
up oil or fuel spillage. Allow machine to cool before storing.
• Stop and inspect the equipment if you strike an object. Repair, if necessary, before
restarting.
• Clean and replace safety and instruction decals as necessary.
To Next Page
Loading...
