PH50B
20195 South Diamond Lake Road, STE 100
Rogers, MN 55374
21
www.maximmfg.com
4. Mount right handle brace to handle along with the bottom mount of the manual tube,
using one 5/16 x 1” bolt, as shown below.
4.2 Throttle Control & Manual holder Installation
1. Position throttle control to right handle along with top mount of manual holder and
fasten with one ¼ x 1 ½” bolt and lock nut.
4.3 Ensure the handle is at desired height and tighten all recently installed
hardware:
1. Throttle Control & Manual holder
2. Bottom handle mounting
3. Lower Handle brace
4. Upper Handle brace
4.4 Clutch Cable Installation
1. Thread looped end of clutch control cable downward through
cable guide clamp, located on left handle brace. Hook bottom of
cable loop to spring, mounted to idler pulley bracket. With
some tension hook other end with chain into “S” link on clutch
lever, located on left handle. See Photo to right:
To Next Page
Loading...
