28
CART STOP LOCK
(DUAL CART
STOPS ONLY)
4. When loading the plat-
form at bed level, make
sure cart stops are open
(FIG. 28-1). Push load
out of the vehicle. Place
all loads as close as
possible to the edge of
the cart stops as shown
in FIG. 28-1. If standing
on platform with the load,
stand in the footprint
area shown and com-
ply with the WARNING
shown above.
Pulling the load from vehicle to platform can result in a fall from
platform and serious injury. When unloading vehicle, always
push the load out on the platform.
WARNING
!
5. Unload platform with cart
stops at ground level as
follows. Make sure cart
stops are closed before
moving load off the plat-
form (FIG. 28-2). To close,
push the cart stop lock
down. Then, step on cart
stop until closed (FIG.
28-2). Move load off the
platform as shown in FIG.
28-2.
NOTE: Cart stops are kept
closed by a cart stop
lock (FIG. 28-2).
USING CART STOPS (IF EQUIPPED) - Continued
LOADING PLATFORM AT BED LEVEL
(DUAL CART STOPS OPEN)
FIG. 28-1
VEHICLE
BODY
PLATFORM
CART STOPS
CART
STOPS
CART STOP
LOCK
UNLOADING PLATFORM AT GROUND
(DUAL CART STOPS CLOSED)
FIG. 28-2
To Next Page
Loading...
