11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
PAGE 15
RUNNER REPLACEMENT
VALVE
BLOCK
COIL
NUT
LOCK VALVE
& COIL
8. Remove the Column Cover from the top
of the Column. Remove the Coil Nut from
the Lock Valve & Coil. Slide off the Coil
and unscrew the Valve Cartridge (screwed
into the Valve Block). Remove the bolts (if
any), that secure the Valve Block to the
Column.
Remove the Nut from the Elbow on
the top of the Cylinder. Loosen, but do not
remove the Nut on the Elbow of the Valve
Block.
Using a device such as a
Chain Hoist, hold the Lift Cylinder
while removing the upper Roll Pin &
Pin. Raise the Cylinder until the Rod
End of the Cylinder clears the top of
the Runner.
9. Grasp the lower end of the Runner and
pull towards the centerline of the vehicle.
The Runner should be free of the Column
by now. Repeat for the other side.
COLUMN
RUNNER
DIRECTION
OF PULL
To Next Page
Loading...
