11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
14
CHANGING HYDRAULIC FLUID
CAUTION
Keep dirt, water and other contaminants from entering the hydraulic system.
Before opening the hydraulic !
uid reservoir " ller cap, drain plug and hydrau-
lic lines, clean up contaminants that can get in the openings. Also, protect the
openings from accidental contamination.
+50 to +120 Degrees F - Grade ISO 32
Below + 70 Degrees F - Grade ISO 15 or MIL-H-5606
NOTE:
Use correct grade of hydraulic ! uid for your location.
See TABLES 13-1 & 13-2 for recommended brands.
PERIODIC MAINTENANCE
2. Unlatch and remove the pump cover
(FIG. 14-1).
3. Place empty 5 gallon bucket under drain
plug (FIG. 14-2). Remove drain plug
(FIG. 14-2). Drain hydraulic ! uid. Re-
install drain plug (FIG. 14-2).
REMOVE PUMP COVER
FIG. 14-1
POWER UNIT
FIG. 14-2
PUMP COVER
LATCHES
(2 PLACES)
PUMP
UNIT
(REF)
DRAIN PLUG
1. Unstow and lower Liftgate to ground.
To Next Page
Loading...
