Maxon RA-45 - Connect WAYPOINT and Charge Controller to Junction Box

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
16
2. Turn the fi ne adjustment bolt (FIG.
16-1B)
to get the minimum 1/4” dis-
tance from edge of platform to trailer
wall (FIGS. 16-1 and 16-1A). Turn-
ing the bolt COUNTERCLOCKWISE
will increase the gap, turning the bolt
CLOCKWISE will decrease the gap.
FINE ADJUSTMENT
(FRONT VIEW)
FIG. 16-1B
FIG. 16-1A
PLATFORM FLUSH
WITH VEHICLE FLOOR
FIG. 16-1
PLATFORM
FLIPOVER
FINE ADJUSTMENT
BOL
T
TRAILER
FLOOR
TRAILER
W
ALL
PLATFORM GAP & STOP ADJUSTMENT
NOTE: Park vehicle on level ground and unload vehicle before doing this procedure.
1.
Run slide assembly out and unfold the fl ipover. Then, raise platform to fl oor level
making sure not to hit trailer wall (FIG. 16-1). If necessary, trim platform plate
(FIG. 16-1A).
1/4” MIN.
EDGE OF
PLA
TFORM
PLATFORM
PLA
TE
NOTE: Refer to Operating Instructions decal and applicable W
ARNING &
CAUTION decals.