ā Do not look directly at the tip of the gun, and always wear safety glasses during
each operation.
4. Electrical Operating Guidelines for the Handheld Laser Welding Machine
Maxphotonicsstronglyadvisesyoutocarefullyreadthefollowingoperatinginstructions
before using the handheld laser welding machine:
(1) Ensure that the machine's outer casing is well grounded; any interruptions in the
grounding loop may result in personal injury.
(2) Before using the device, ensure that the power supply connected to it is also
connected to a protective ground.
(3) To minimize fire risk, only replace fuses with the same type and rating when
necessary; do not use other fuses or materials for this purpose.
(4) Verify that the handheld laser welding machine's input AC voltage lies within the
normal AC mains voltage range (single-phase voltage 200-240VAC) and that the
wiring is correct. Improper wiring may lead to personal or equipment injury.
(5) Users should not attempt repairs on parts, components, or assemblies other than
the gun head consumables. All maintenance operations should be performed by
Maxphotonics professionals.
(6) Unauthorized disassembly and reassembly of the handheld laser welding
machine are strictly prohibited, as doing so may result in electric shock or burns, and
damage to relevant labels.
(7) Keep flammable materials away from the welding area, as the heat and sparks
generated during the process may cause fires or explosions. Perform laser welding
only in areas free of combustible materials.
(8) Do not weld on containers holding flammable or combustible substances. If a
container's contents are unknown, assume they are flammable or combustible. Keep
fire extinguishers nearby, easily accessible, and ensure personnel are trained to
use them.
(9) Disassembling any product without permission will void the warranty rights.
To Next Page
Loading...
Need help?
General
