MAXPhotonics MA1 Series User Manual

10-Maintenance and Troubleshooting of Wire Feeders
1. Check regularly:
Regular Inspections: Before using the wire feeder, ensure to examine the
following components for any damages:
(1) Control cables and their connectors
(2) Power supply and functionality of the wire feeding button
(3) Switch locking mechanism
11-Routine Maintenance
(1) Inspect the wire feeding wheel and pressing wheel:
Examine the groove section of the wire feeding wheel and the wear condition of
the pressing wheel, ensuring there are no impurities in the groove. Replace them
if wear is severe.
(2) Inspect the wire feeding pipe:
Verify if the connectors at both ends of the wire feed pipe are loose and if the
stainless steel pipe (graphite pipe & teflon pipe) is obstructed. Use compressed air
to clear any minor blockages caused by metal chips. Replace the wire feed pipe if
the blockage is significant.
(3) Check the motor:Listen for any abnormal sounds coming from the motor..
(4) Clean the equipment:Thoroughly clean and purge the equipment at least once a month.
60

MAXPhotonics MA1 Series Specifications

General

Brand	MAXPhotonics
Model	MA1 Series
Category	Welding System
Language	English