efficiency. If the device overheats, do not use it and call Maxphotonics for help.
When the temperature of the laser is too high, the device will trigger an alarm and
stop emitting light.
To ensure a safe laser work area, the interaction between the laser and the work
surface, which can create additional safety hazards due to the high temperatures
that generate gases, sparks and debris. The corresponding operators need to go
through certain assessment and training, and be familiar with and master the
general safety regulations of laser operation.
Maxphotonics advises taking the following steps to extend the lifespan of your
handheld laser welding machine
(1) Ensure proper ventilation in the work area and place the machine in a dry, cool,
and clean environment. Avoid exposure to high temperatures, humidity, and water
hazards.
(2) When operating the machine, make sure no foreign objects block the air intake
at the bottom of the laser and keep the area within 1 meter clear of debris for
uninterrupted airflow. Ensure the top air outlet is elevated by 1 meter.
(3) Avoid allowing any debris (including liquids) to enter the laser from the top, as
this may damage the machine and potentially cause personal injury.
(4) Operating the equipment at high temperatures can accelerate aging, increase
the current threshold, and decrease the machine's sensitivity and conversion
efficiency. If the device overheats, stop using it and contact Maxphotonics for
assistance.
NOTICE :
◎
Handle the equipment with care to prevent accidental damage.
◎ Periodically clean the filter at the bottom of the laser to remove dust and debris from
the air inlet.
To Next Page
Loading...
Need help?
General
