Wire feed nozzle 0.8-1.6mm
To adjust the wire feeding speed, follow these steps:
(1) 1. Activate the wire feeding switch on the touchscreen interface.
(2) 2.Disable the laser function.
(3) 3.Press and hold the handheld welding head switch.
(4) 4.Initially set the wire feeding speed to a low rate (approximately 10mm/s) for adjustments.
(5) 5.Depending on the wire feeding pressure, turn the two adjustable preload pressure rods'
sleeves left or right.
(6) 6.Continue adjusting until the wire reel rotates at a consistent speed. Make sure that the
wire feeding tube is straight and unbent, ensuring optimal wire delivery..
To Next Page
Loading...
Need help?
General
