Page 23
Connecting to a Satellite Receiver
The satellite cables must connect to the Control Box. The Control Box will then output this signal through the F
connector marked ‘RECEIVER’. In order for the satellite signal to pass through the Control Box the power must be
on.
Power Consumption
The Connect has been designed to minimise power consumption.
When the Connect is not used for long periods of time it is recommended to switch off the Control Box.
The Ignition Mode will still activate even with the Control Box power switch in the off position.
When power is restored to the system the antenna will automatically lower into the park position.
Page 20
To Next Page
Loading...
