Mayer MMD013C - Page 14

13
250°C
1h
Conventional
Heating Mode
Temperature
Time
SETTING
After the appliance has cooled down:
1.
2.
3.
Setting the time
Before the oven can be used, the time should be set.
1.
2.
3.
NOTE: The clock has a 24 hour display.
Clean the smooth surfaces and the door with soapy water and a dish cloth.
Dry all surfaces.
Install the side-racks.
After the oven has been electrically connected, touch the clock symbol then you can
set time of day in hours by slider or “+/-“symbol.
Touch clock symbol again then you can set time in minutes by slider or “+/-“symbol.
Touch clock symbol to nish the setting.
using the appliance to prepare food for the rst time, you must clean the
cavity and accessories.
1.
2.
3.
4.
5.
6.
7.
8.
Remove all stickers, surface protection foils and transport protection parts.
Remove all accessories and the side-racks from the cavity.
Clean the accessories and the side-racks thoroughly using soapy water and a dish
cloth or soft brush.
Ensure that the cavity does not contain any leftover packaging, such as polystyrene
pellets or wooden piece which may cause risk of re.
Wipe the smooth surfaces in the cavity and the door with a soft, wet cloth.
To remove the new-appliance smell, heat up the appliance when empty and with the
oven door closed.
Keep the kitchen highly ventilated while the appliance is heating up rst time. Keep
children and pets out of the kitchen during this time. Close the door to the adjacent
rooms.
Adjust the settings indicated. You can nd out how to set the heating type and the
temperature in the next section.
CONTROLS AND OPERATIONS