Maytag LAT8014 - Extra Rinse Option; Warm Rinse Option; Start the Washer; Program Monitor Features

5. Cancel the presoak option by
pressing the pad a second time.
The indicator light will also go out.
Extra Rinse
An
additional deep rinse is automat-
ically added to the selected cycle by
using the EXTRA RINSE option. To
select,
press the EXTRA RINSE pad.
The
water temperature will be the same
as the initial rinse.
Warm Rinse
Pressing this pad will provide a warm
final rinse when energy saver hot,
warm or energy saver warm water tem-
peratures are selected. A warm final
rinse cannot be provided on a perma-
nent press cycle or when using a hot or
cold wash temperature on any cycle.
Start the Washer
After a wash cycle program has been
selected,
the washer will fill to the
selected water level with the selected
wash water temperature. After filling, it
will agitate for the selected number of
minutes.
The washer will pause brieUy
throughout each cycle. These pauses
are normal.
This washer is designed so that it will
not agitate or spin when the lid is open.
It
will, however, fill with the lid open so
16001145
water is available for pretreating stains
or diluting fabric softener.
Should
the lid be opened during a
cycle,
the washer will stop; when the lid
is closed, the washer will resume it's
cycle at the point it was interrupted.
Program Monitor Features
Unbalanced Signal If the washer
becomes unbalanced, "UNBALANCED"
will light in the Monitor. One minute
later an audible signal will sound. This
signal will continue to sound every
minute. To continue the cycle, redis-
tribute the load and close the lid. The
washer will automatically resume the
cycle at the point it was interrupted.
Sequence Indicators
Words light in the Monitor as the
washer advances through each portion
of the cycle - "Soak, Wash, Rinse,
X-Rinse
and Spin."
The following display symbols indicate:
Soil Level Indicators
The soil level indicators will light in the
Monitor to help match the wash time to
the soil level of the load. For example,
if the load is lightly soiled, agitation
time can be decreased and fewer indi-
cator lights will light indication appro-
priate agitation time for the load.
SECTION 2. CONTROLS 2-8
I
©1994 Maytag Corporation