Maytag LAT8014 - Belts Service; Replacing Belts; Belt Guard

BELTS
3. Stick your hand through the access
hole and guide the belt around the
drive pulley.
,.
Replacing Belts
The belts can be replaced using two dif-
ferent methods. One method is tilting
the washer back and replacing the
belts. The other is by removing the
front panel and using the access hole in
the base frame. The access hole is put
in
the base frame in the event the
washer cannot be tilted back.
To change the belts using the access
hole:
1.
Remove front panel.
2. Grasp the drive belt at the end that
goes on the motor pulley. Squeeze
this end together. This will form a
loop on the other end. Insert belt 4. Push motor towards transmission.
under washer with the loop end
Loop belt over motor pulley and
towards the drive pulley.
rotate it into position
5.
Replace pump belt and check the
pump belt tension (refer to section
covering adjustment for pump belt
tension).
6. Replace front panel and check oper-
ation of the washer.
Belt Guard
The belt guard is secured to the front
panel by three sheet metal screws
through the long lip of the belt guard
and lower lip at the base of the front
panel.
Attaching the belt guard in this manner
makes it unnecessary to remove it from
the front panel since it will be automat-
ically removed and replaced with the
front panel.
16001145
SECTION
3. WASHER - SERVICE PROCEDURES 3-30
©1994 Maytag Corporation