Maytag LAT8014 - Front Panel Service

Hold the lid with the left hand keeping
sufficient pressure against the left side
to ensure the hinge ball will remain
wedged between the lid and the top
cover. With the right hand, place a
hinge ball in the right side of the top
cover recess.
Push
the lid down against the hinge ball
on the right side and with the right
thumb, press down sharply to engage
the lid with the hinge ball on the right
side.
Note: If the fit between the right hinge
ball and the lid is so tight you cannot
press it into position with the right
thumb, carefully strike the right corner
of the lid with the palm of the hand to
snap it into position.
FRONT PANEL
To Remove Front Panel:
1. Remove the two screws under the
edge at bottom of front panel.
2. Swing front panel out from bottom to
disengage spring fasteners from top
cover.
With the front panel off, you have
access to the motor, pump, top cover,
hoses and transmission.
16001145
SECTION 3. WASHER - SERVICE PROCEDURES 3-19
©1994 Maytag Corporation