Maytag LAT8014 - Page 46

agitate for the selected number of
minutes.
The washer will pause briefly
throughout each cycle. These pauses
are normal.
This washer is designed so that it will
not agitate or spin when the lid is open.
It
will, however, fill with the lid open so
water is available for pretreating stains
or diluting fabric softener.
Should the lid be opened during a
cycle,
the washer will stop; when the lid
is closed the washer will resume it's
cycle at the point it was interrupted.
16001145
Note: If an unbalanced load occurs
during the spin, the washer will atom-
ically stop. If this happens, push in the
control knob, wait for the tub to stop
spinning, open
the lid, redistribute the
load, close the lid and pull out the
control knob.
Indicator Lights
(Lights will vary according to model)
The ON light stays lit throughout the
entire cycle indicating the washer is
operating. The SOAK light is on during
the presoak cycle.
SECTION 2. CONTROLS 2-14
©1994 Maytag Corporation