Maytag LAT8014 - Page 64

Start the Washer
Pull out the cycle control knob to start
the washer. It will fill to the selected
water level with the selected wash
water temperature. After filling, it will
agitate for the selected number of
minutes.
The washer will pause briefly
throughout each cycle. These pauses
are normal.
This washer is designed so that it will
not agitate or spin when the lid is open.
It
will, however, fill with the lid open so
water is available for pretreating stains
16001145
or diluting fabric softener. However,
when returning saved water the lid
must be closed. Should the lid be
opened during a cycle, the washer will
stop; when the lid is closed and the
control knob is pulled out, the washer
will resume its cycle at the point it was
interrupted.
NOTE: If an unbalanced load occurs
during the spin, the washer will auto-
matically stop. If this happens, push in
the control knob, wait for the tub to stop
spinning, open
the lid, redistribute the
load, close the lid and pull out the
control knob.
SECTION 2. CONTROLS 2·32
•
©1994 Maytag Corporation