To Next Page

To Previous Page

Setting the pH Set Point

The default pH Set Point of 7.6 is suitable for most pool

systems. You should only change this setting if advised by

a pool professional.

Press Setup to enter the user-friendly menu system,

then press ‡ and ˆ until pH Set Point is selected. The

current Set Point is shown in brackets.

Press Enter to go to the pH Set Point menu.

Press ‡ and ˆ to set the required pH Set Point.

Press Enter to save the new setting, or press Cancel to

quit without saving.

Pool Size Setting

The pH correction demand and pool turnover time is

different from pool to pool, even when two pools are the

same size. The Pool Size setting will be suitable for the

majority of pools. However, it may be necessary to adjust

this during the first few days or weeks of operation, as

detailed in this section.

Press Setup to enter the user-friendly menu system,

then press ‡ and ˆ until Pool Size is selected. The

current Pool Size setting is shown in brackets.

Press Enter to go to the Pool Size menu.

Press ‡ and ˆ to set the required Pool Size.

Press Enter to save the new setting, or press Cancel to

quit without saving.

NOTES

If the pH Drive does not keep up with acid or base demand,

and the Alarm sounds, increase the Pool Size setting by

one step and check in 2 days.

If the pH Drive overdoses too much acid or base, reduce

the Pool Size setting by one step and check in 2 days.

New concrete pools have an extremely high acid demand

for the first few months. It may be necessary to enter a

Pool Size up to 50% more than the true size of the pool if

your pH Drive is not keeping up with acid demand during

this initial period. The setting can be reduced again 1 to 3

months later.

pH Drive Settings

Maytronics pH Drive User Manual

Questions and Answers: