Body & Accessories Control System
Control System
Features
• The control system of the BT-50 has the following new features:
– DLC-2
– HS-CAN connection between PCM and DLC-2 for communication with M-MDS
Data Link Connector
• The DLC-2 is located under the dashboard next to the centre panel.
• The 17-pin DLC-1, known from the previous B-Series, is installed on the left rear side in
the engine compartment. It cannot be used for communication with M-MDS.
NOTE: For communication with M-MDS the control modules of the ABS (Antilock-Brake
System) and the SAS are connected to DLC-2 via ISO (International Standard
Organisation) bus.
Service Training BT-50 09-25
To Next Page
Loading...
