WL-C Engine Control System
Camshaft Position Sensor
• The Hall-type CMP sensor is installed at the right front side of the cylinder head. A
projection on the intake camshaft pulley covers 26° camshaft rotation angle.
BT-50_01051
1 CMP sensor 4 Pulse wheel
2 PCM 5 Intake camshaft pulley
3 CPU 6 Gap (1,4 mm)
NOTE: When the CMP signal fails during engine operation, the engine continues to run and
will start again (with little extended cranking time) after it has been shut off.
Service Training BT-50 01-47
To Next Page
Loading...
