Power window system initialization
procedure
If the battery was disconnected during
vehicle maintenan ce, or for other reasons
(such as a switch continues to be operat ed
after the window is fully open/closed), the
window will not fully open and close
automatically.
The power window auto function will
only resume on the power window that
has been reset.
1 Switch the ignition ON.
2 Make sure that the power window lock
switch located on the drive r's door is
not depressed.
3 Press the switch and fully open the
window.
4 Pull up the switch to fully close the
window and continue holding the
switch for about 2 seconds after the
window fully closed.
Jam-safe window
If a person's hands, head or an object
blocks the window during the auto-
closing operation, the wi ndow will stop
and open halfway.
WARNING
Make sure nothing blocks the window
just before it reaches the full y closed
position or while holding up the power
window switch:
Blocking the power window just
before it reaches the fully closed
position or while holding up the power
window switch is dangerous.
In this case, the jam-safe function
cannot prevent the window from
closing all the way. If fingers are
caught, serious injuries could occur.
NOTE
l
Depending on driving conditions, a
closing power window could stop
and start opening when the win dow
feels a shock that is similar to
something blocking it.
In the event the jam-safe function
activates and the power window
cannot be closed automatically, pull
and hold the switch and the window
will close.
l
The jam-safe window function does
not operate until the system has been
reset.
Engine-off power window operation
The power window can be operated for
about 40 seconds after the ignition is
switched from ON to off with all doors
closed. If any door is opened, the power
window will stop operat ing.
Before Driving
Windows
3-41
To Next Page
Loading...
