Key Battery Replacement
If the buttons on the transmitter are
inoperable and the operat ion indicator
light does not flash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
CAUTION
l
Make sure the battery is installed
correctly. Battery leakage could
occur if it is not installed correctly.
l
When replacing the battery, be
careful not to touch any of the
internal circuitry and electrical
terminals, bend the electrical
terminals, or get dirt in the
transmitter as the transmitter could
be damaged.
l
There is the danger of explosion if
the battery is not correctly replaced.
l
Dispose of used batteries according
to the following instructions.
l
Insulate the plus and minus
terminals of the battery using
cellophane or equiva lent tape.
l
Never disassemble.
l
Never throw the battery into fire
or water.
l
Never deform or crush.
l
Replace only with the same type
battery (CR2025 or equivalent).
The following conditions indicate that the
battery power is low:
l
The KEY indicator light (green) flashes
in the instrument cluster for about 30
seconds after the engine is turned off
(for vehicles with a type A meter,
messages are displayed in the
instrument cluster).
l
The system does not operate and the
operation indicator light on the
transmitter does not flash when the
buttons are pressed.
l
The system's operational range is
reduced.
Replacing the battery at an Authorised
Mazda Repairer is recom mended to
prevent damage to the key. If replacing
the battery by yourself, follow the
instruction below.
Replacing the key battery
1. Press the knob and pull out the
auxiliary key.
Knob
6-42
Maintenance and Care
Owner Maintenance
To Next Page
Loading...
