Rear Window Wiper and
Washer
The ignition must be switched ON.
qRear Window Wiper
Turn the wiper on by turning the rear
wiper/washer switch.
Switch Position
Wiper operation
No.
Type
A
Type
B
Intermittent
Normal
qRear Window Washer
To spray washer fluid, turn the rear wiper/
washer switch to the
position. After
the switch is released, the washer will
stop.
If the washer does not work, inspect the
fluid level (page 6-34). If it's normal and
the washer still does not work, consult an
expert repairer, we recommend an
Authorised Mazda Repairer.
Headlight Washer
í
The engine must be started and the
headlights must be turned on.
If you want to operate headlight washers,
double flick the wiper lever.
Washer
OFF
NOTE
l
If the front washer is operated first
after turning on the headlights, the
headlight washer operates
automatically.
l
If air enters the headlight washer
fluid pipe under conditions such as
when the vehicle is brand-new or
after an empty washer tank is
replenished with washer fluid,
washer fluid will not spray even
when the wiper lever is operated. If
this occurs, perform the following
procedure:
1. Start the engine.
2. Turn on the headlights.
3. Double flick the wiper lever several
times until the washer fluid sprays.
When Driving
Switches and Controls
4-95
í
Some models.
To Next Page
Loading...
