NOTE
l
The headlights, other exterior lights and instrument panel illumination may not turn
off immediately even if the surrounding area becomes well-lit because the light sensor
determines that it is nighttime if the surrounding area is continuously dark for several
minutes such as inside long tunnels, traffic jams inside tunnels, or in indoor parking
lots.
In this case, the lights turn off if the light switch is turned to the
position.
l
The instrument panel illumination can be adjusted by rotating the knob in the
instrument cluster. Also, the antidazzle mode can be changed by rotat ing the knob
until a beep sound is heard. To adjust the brightness of the instrument panel
illumination:
Refer to Instrument panel Illumination on page 4-25.
l
The sensitivity of the AUTO lights may be changed.
Refer to Personalisation Features on page 9-12.
qHeadlight High-Low Beam
Press the lever forward to turn on the high
beams.
Pull the lever back to its original position
for the low beams.
The headlight high-beam indicator light in
the instrument clust er illuminates while
the high beams are turned on.
High beam
Low beam
qFlashing the Headlights
Can be used when the ignition is switched
ON.
To flash the headlights, pull the lever fully
towards you (the headlight switch does
not need to be on). The headlight high-
beam indicator light in the instrument
cluster illuminates simultaneously. The
lever will return to the norm al position
when released.
OFF
Flashing
4-84
When Driving
Switches and Controls
To Next Page
Loading...
