Function for cancelling illumination dimmer
When the headlight switch is in the
or position, the brightness of the Blind Spot
Monitoring (BSM) warning lights is dimmed. If the Blind Spot Monitoring (BSM) warning
lights are difficult to see due to glare from surrounding brightness when travelling on
snow-covered roads or under foggy conditions, press the dimmer cancellation button to
cancel the dimmer and increase the brightness of Blind Spot Monitoring (BSM) warning
lights when they turn on.
Refer to Instrument pa nel Illumination on page 4-25.
Blind Spot Monitoring (BSM) warning beep
The Blind Spot Monitoring (BSM) warning beep is activated simultaneously with the
flashing of a Blind Spot Monitoring (BSM) warning light.
q
Blind Spot Monitoring (BSM) Switch
When the Blind Spot Monitoring (BSM)
switch is pressed, the Blind Sp ot
Monitoring (BSM) and Rear Cross Traffic
Alert (RCTA) systems are turned off and
the Blind Spot Monitoring (BSM) OFF
indication/indicator light in the instrument
cluster turns on.
If the switch is pressed again, the Blind
Spot Monitoring (BSM) and Rear Cross
Traffic Alert (RCTA) systems become
operable and the Blind Spot Monitoring
(BSM) OFF indication/indicator light
turns off.
NOTE
l
When the ignition is switched off,
the condition before the syst em was
turned off is maintained. For
example, if the ignition is switched
OFF while the Blind Spot
Monitoring (BSM) and Rear Cross
Traffic Alert (RCTA) systems are
operational, the Blind Spot
Monitoring (BSM) and Rear Cross
Traffic Alert (RCTA) systems remain
operational the next time the ignition
is switched ON.
l
The Blind Spot Monitoring (BSM)
and Rear Cross Traffic Alert (RCTA)
systems are turned off when the
battery is disconnected such as when
the battery terminal s or fuses have
been removed and re-installed. To
turn the Blind Spot Monitoring
(BSM) and Rear Cross Traffic Alert
(RCTA) systems back on, press the
Blind Spot Monitoring (BSM)
switch.
4-146
When Driving
i-ACTIVSENSE
To Next Page
Loading...
