2. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finge r and
pulling the connector.
CAUTION
When replacing the bulb always
disconnect the connector first.
Otherwise, electric and electronic
devices could be shorted.
3. Insert the flathead screwdriver into the
gap between the lens and the lens unit,
and then slide the screwdri ver to detach
the lens.
4. Disconnect the bulb by pulling it out.
5. Install the new bulb in the reverse order
of the removal procedure.
Maintenance and Care
Owner Maintenance
6-61
To Next Page
