NOTE
l
Check the tyre inflation pressure
label (driver's door frame) for the
correct tyre inflati on pressure.
l
Do not use the compressor for longer
than 10 minutes because using the
compressor for long periods could
damage it.
l
If the tyre does not inflate, repair of
the tyre may not be possible. If the
tyre does not reach the correct
inflation pressure within a 10-minute
period, it probably has received more
extensive damage. When this
happens, the emergency flat tyre
repair kit cannot be used to repair the
tyre. Contact an expert repairer, we
recommend an Authorised Mazda
Repairer.
l
If the tyre has been over-inflated,
loosen the screw cap on the
compressor and bleed some of the air
out.
16. When the tyre has been inflated to the
proper inflation pressure, turn the
compressor switch off and remove the
compressor hose from the tyre valve.
17. Install the tyre valve cap.
18. Put the emergency flat tyre repair kit
in the boot and continue driving.
CAUTION
l
Drive carefully to an expert repairer,
we recommend an Aut horised
Mazda Repairer and keep the vehicle
speed below 80 km/h (50 mph) .
l
If the vehicle is driven 80 km/h (50
mph) or higher, the vehicle might
begin to vibrate.
NOTE
(With Tyre Pressure Monitoring
System)
If the tyre is not properly inflated, the
tyre pressure monitoring system
warning light will illuminate (page
4-33).
19. After driving the vehicle for 10
minutes or 5 km (3 miles), check the
tyre pressure with the tyre pressure
gauge equipped with the compressor.
If the tyre pressure has fallen below
the correct tyre pressure, inflate the
tyre to the correct pressure again
following the steps from number 14.
If Trouble Arises
Flat Tyre
7-13
To Next Page
Loading...
