BODY STRUCTURE [PANEL REPLACEMENT]
09-80B–78
REAR FLOOR PAN INSTALLATION[PANEL REPLACEMENT]
id098008742800
1. When joining and cutting the new and existing parts, trial fit the new part in position, then measure and adjust
the body as necessary to conform with standard dimensions.
2. Cut area (A) on new part.
3. Drill holes for the plug welding before installing the new parts.
4. Apply spot sealer to the areas where both the overlapping ends of the new and existing parts will be welded.
Adhere the sections to be welded, and fillet weld along both seams at the locations indicated by (B).
Note
• Create a flange with flanging tool where new and existing parts are joined.
5. Weld the remaining weld locations, then install the rear floor pan.
REAR FLOOR PAN
13
10
60mm {2.36in}
13
10
CUT-AND JOIN
LOCATION
A-A
CROSSMEMBER No.4
A
A
NEW PARTS
EXISTING PARTS
(B)FILLET WELDING
(A)
acxuub00000142
3419-1U-06C(09-80B).fm 78 ページ ２００６年３月２４日 金曜日 午後４時４７分
To Next Page
Loading...
