BODY STRUCTURE [PANEL REPLACEMENT]
09-80B–46
FRONT PILLAR INSTALLATION[PANEL REPLACEMENT]
id098008744800
1. To cut and join the new and existing parts, cut the new part at the specified location shown in the figure, and
chamfer the joint surfaces of the new and existing parts.
2. Drill holes for the plug welding before installing the new parts.
3. Apply body sealer to the joints of old and new parts for waterproofing and rust protection.
4. Install the front pillar (inner).
2
1
FRONT PILLAR (INNER)
CUT-AND JOIN
LOCATION
190mm
{7.48in}
acxuub00000100
3419-1U-06C(09-80B).fm 46 ページ ２００６年３月２４日 金曜日 午後４時４７分
To Next Page
Loading...
