GENERAL INFORMATION
00-00–12
EFFICIENT INSTALLATION OF BODY PANELS
id000000600500
Checking Preweld Measurements And Watching
• Align to the standard reference dimensions,
based upon the body dimensions illustration, so
that new parts are installed in the correct position.
Welding Notes
• For the number of weld points, welding should be
performed in accordance with the following
reference standards.
Spot Welding Notes
• The shape of the spot welder tip is D=(2×t)+3. If
the upper panel thickness is different from that of
the under panel, adjust to the thinner one.
• Because the weld strength is affected by the
shape of the spot welder tip, the optimum
condition of the tip should always be maintained.
• Spot welds should be made at points other than
the originally welded points.
acxuub00000069
Spot welding
Original weld
If 3mm
{0.12in} or more
Original number of
welds x 1.3 or more
CO
2
arc welding
Original spot weld
Repair weld
Repair weld
Original number of welds
or more
acxuub00000053
D
70 - 120°
t
acxuub00000054
acxuub00000070
3419-1U-06C(00-00).fm 12 ページ ２００６年３月２２日 水曜日 午後４時１４分
To Next Page
Loading...
