GENERAL INFORMATION
00-00–4
Symbols of Panel Replacement
• The following 6 symbols are used to indicate the type of weld that is used when replacing body panels.
Body Dimensions (Flat-plane Dimensions)
• Flat-plane dimensions are the dimensions measured by projecting certain reference points onto a plane
surface.
• When there are no specific indications, the standard points and dimensions are symmetrical in regard to the
center of the vehicle.
• The hypothetical lines may differ according to the vehicle model.
• The schematic diagram shows the vehicle as it is projected from the underbody.
SYMBOL
MEANING
Spot welding
CO
2
arc welding (plug welding)
CO
2
spot welding
SYMBOL
MEANING
Continuous MIG welding (Cut-and-join location)
Braze welding
Rough cut location
acxuub00000032
810
{31.89}
FLAT-PLANE DIMENSIONS
FRONT FENDER INSTALLATION NUT
acxuub00000033
3419-1U-06C(00-00).fm 4 ページ ２００６年３月２２日 水曜日 午後４時１４分
To Next Page
Loading...
