BODY STRUCTURE [PLASTIC BODY PARTS]
09-80E–5
09-80E
2. Weld the damaged area.
• For repair of a cracked area, melt the crack together with a heat gun and a melting attachment.
• For repair of a hole, degrease the area on
both sides of the bumper and apply aluminium
tape on the reverse side of the damage area.
3. Melt the polypropylene welding rod with a heat
gun and deposit it the cracked area.
Note
• Heat the shaded area to melt it.
• Take care not to overly melt welding rod. If the part is welded with the welding rod melted like jelly, the
welding strength will be reduced.
• Hold the heat gun 10—20 mm {0.39—0.79 in} from the part being welded.
• Do not move the welding rod until the welded parts cool.
Polypropylene surface
Heat gun
Attachment for
melting
painted surface
Melt together
B-B,C-C Section
Section after melting
am8rrb00000052
A-A Section
Degrease
Aluminium tape
am8rrb00000053
Polypropylene welding rod
Polypropylene welding rod
Melt this area
Melted area
B-B,C-C,D-D Section
am8rrb00000054
Polypropylene welding rod
Polypropylene welding
Paint
Top view
A-A Section
Surface
Aluminium tape
am8rrb00000055
3419-1U-06C(09-80E).fm 5 ページ ２００６年３月２２日 水曜日 午後６時２８分
To Next Page
Loading...
