ENGINE
B–35
B
Rear Oil Seal Assembly Note
1. Apply silicone sealant to the mating faces as
shown.
Dot diameter:
4.0—6.0 mm {0.16—0.23 in}
2. Apply clean engine oil to the new oil seal lip.
3. Install the rear oil seal using the installer as
shown.
4. Tighten the rear oil seal bolts in the order as
shown.
Tightening torque:
8.0—11.5 N·m {81.6—117.2 kgf·m, 70.9—
101.7 in·lbf}
1 Rear oil seal
(See B–35 Rear Oil Seal Assembly Note)
2 End plate (MPV)
3 Flywheel (MTX), Drive plate (ATX) (See B–36 Drive
Plate (ATX), Flywheel (MTX) Assembly Note)
4 Oil pump
5 Oil strainer
6 Water pump
7 Thermostat
8 Oil separator
9 Knock sensor
10 Oil cooler
11 Oil filter adapter
12 Oil filter
13 Oil filter cover
14 Oil pan
(See B–36 Oil pan Assembly Note)
15 MTX
AME2224E325
AME2224E326
AME2224E002
1731‑1E‑02C.book35ページ２００２年４月２６日 金曜日 午前１０時３０分
To Next Page
Loading...