MB ZTS - Assembly Instructions; Pre-Assembly Inspection and Mounting

8
Publication: ZTS-080812
M-B Companies, Inc. 11/15/12
INTRODUCTIONASSEMBLY
The ZTS Sweeper is designed to be used with Zero Turn lawn tractors.
Do no make any modications to the attachment, the mounting frame
or associated hardware. Any modications may void the equipment
warranty.
PRE-INSPECTION
Review the list below to identify and validate that all the required
parts and fasteners are present. Contact M-B Companies if items are
missing. Additional fasteners and clips can be purchased locally.
Figure 2
Loose Parts
QTY Description
2 Caster Wheel, 5" 3/4"
2 HHCS .25-20 UNC x 1.500
1 HHCS 3/8-16 UNC x 1.750
2 Nut, Hex ESNA, 1/4-20 NC
2 Pin, Clevis 1/2 x 2-1/2
2 Tube, Caster
1 Rod Swing CTRL
1 Swing Tube Assy
1 Head Assembly, ZTS 60"
1 Actuator, Linear 4" Stroke Electric Option Only
ASSEMBLY
The attachment mount should already be mounted to the tractor.
Installation of the attachment mount is described in the publication for
the Zero Turn Attachment Mount to be used with your tractor.
If this tractor will be using the manual lift and swing controls, install the
guide bracket.
a. Position the bracket on top of the front lift assist mount.
b. Use two bolts with washers and nuts to secure it in place.
B
Figure 3
The following steps describe how to mount the broom head.
1. Open the attachment pins.
a. Pull out on both pins and rotate to hold them in the out
position.
A
Figure 4
2. Mount the broom head.